Angle feeder

The angle feeder is installed between the basket conveyor or return table and the dishwasher. Dish baskets are manually pulled into the angle feeder, from where they are automatically conveyed to the dishwasher. The equipment is attached to the dishwasher tray. Thanks to the slanted bottom, water flows effectively off into the dishwasher.

Turntable 90°

The turntable is installed between the basket conveyor and the dishwasher. The feed direction can be clockwise or anti-clockwise. The table is attached to the dishwasher tray. Thanks to the slanted bottom, water flows effectively off into the dishwasher.

Turntable 180°

The turntable is installed between the basket conveyor and the dishwasher. The feed direction can be clockwise or anti-clockwise. The table is attached to the dishwasher tray. Thanks to the slanted bottom, water flows effectively off into the dishwasher.

Further information

General

The dishwasher the equipment is connected to must be stopped for the duration of the cleaning.
Do not use steel wool or abrasive detergents for cleaning stainless steel surfaces. If you use a detergent that contains chlorine, be sure to rinse carefully. If chlorine or chlorine compounds come into contact with stainless steel, this may result in corrosion damage.

Daily cleaning

The equipment must be cleaned after use. Use warm water and neutral dishwashing/cleaning detergent. Rinse the bottom clean.

Weekly cleaning

Clean the equipment from the outside using a damp cloth. Use warm water and neutral dishwashing/cleaning detergent.

Request an offer.